Posted by Jim in TX on June 27, 2016 at 12:58:53 from (75.53.157.116):
In Reply to: Pole barn restoration posted by Pete in Holland MI on June 27, 2016 at 10:08:21:
Second the Perma Column solution. You do not have to buy the bracket and concrete post assembly (heavy, a fortune to ship). The bracket is available separately and you can make a mold to cast the post onsite OR cut off the existing posts, install the bracket, add a round cardboard form fill with concrete. If you brace the roof you can cut the post, use a small excavator to pull the old post, dig the hole, fill around new post or round form. No BS hand digging.
Plus the finished job will look like a pro job instead of midnight engineering.
Bagged concrete is available as "Dot 3" it is high strength quick set for the molded posts and is used by your local hwy dept for overnight road repair. Some brackets use Simpson Strong Tie fasteners to increase the loading capacity of the wood to concrete joint in the bracket.
Simpson has brackets also. They will require a round tube form and use of the same fasteners. Download a copy of the Simpson catalog/application guide.
No interest in Perma Column or Simpson. I had planned to build a wood frame shop using the Perma Column brackets and casting the posts onsite. Decided that it was just a easy to rent an excavator cut 12" X 2 ft trench fill with concrete and stab the brackets in. Cheaper too! Don't know cost of Dot 3, but I'd venture anything the govt buys will be Cadillac price.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.