Posted by Geo-TH,In on July 02, 2016 at 04:49:41 from (172.78.5.74):
Years ago Terre Haute had a Nitrogen plant on the north side of town. They used NG to make fertilizer. Closed because the cost of NG shot up. Now on the west side of the river, Duke's coal gasification plant is being taken out of production and it's going to be converted into a fertilizer plant. They are going to use coal. That was news to me that coal can be used to make fertilizer, but after researching the topic, I discovered the technology goes back to WWII.
Once fertilizer was made using NG, now coal. Electricity was made using coal, now NG. Just wondering if the new fertilizer plant coming to Terre Haute will be able to use Indiana coal, or will they have to use coal with less sulfur? Relatively speaking, If all fertilizer plants in the US used coal, how would compare to the amount of coal used to make electricity? Will coal reduce the cost of fertilizer?
While researching, I also discovered that the EPA approves fly ash as a fertilizer too. I find it ironic that fly ash can't be buried, it could cause water to be contaminated, but an old 2009 article says there isn't enough toxic materials, so it too can be used as a fertilizer. Not sure if EPA has reversed it opinion of fly ash.
I found it funny that the same materials in fly ash were once in the ground, but they couldn't be put back in the ground but you can spread it on the fields. Also heard that some concrete companies will put fly ash in there mix. Some say that causes the concrete to chip easier. Not sure of this, call it hear say. Others tell me you have to request your concrete not have fly ash. Again hear say, not sure.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.