Posted by Deere Scotty on July 04, 2016 at 12:40:36 from (68.38.176.107):
In Reply to: Now it's baler twine? posted by Fred Werring on July 04, 2016 at 12:02:53:
My dad being the Civil Engineer that He was reset the bale Counter sometimes just to check how many bales He got from however many twine rolls He put in it. More than once He went back with complaints; but I cant remember now what brand the store was selling. Small bales by the way. It would be a lot harder to tell with a round baler.
KEEP AN EYE OUT! They cut the length once; but now what will they do when they have to cut costs again!!! Probably cut quality? I remember one of the trips back to the store dad put the spool of twine on the ground, & grabbed the end, walked about 100 feet, & found 5, or 6 severe week spots. We were braking bales at an alarming rate. That would have been around the early part of the farm crisis. Person behind the counter said he knew the manufactures were cutting costs severely to stay in business.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
