The cab and loader will make splitting the tractor real fun!!! I would make sure you did in fact blow the clutch. The only way you would have done that is being in too low of a gear and pulling it faster than it would normally go in that gear. IF you did indeed tear your clutch out I would NOT try to split it with out having a flat concrete surface to split it on, especially with a cab. You do not need a shop but you do need a solid flat surface to support jacks/blocks/stands/etc. I have done splits in cattle yards before.
As far as special tools you will need an alignment shaft but you can buy a simple alignment tool kit from from Lisle tool. It works fine on single disk clutches.
As for the labor time to split the tractor and replace the clutch. With the loader and cab it could real easily take 15-20 hours of labor for the complete job. I would estimate $1250-1500 for labor only and that is if you do not have AC on the cab. Add a few more hours if you have AC.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
