Posted by littlefarmer on July 20, 2016 at 10:10:02 from (173.85.190.42):
In Reply to: Barn Paint posted by ekarbt on July 20, 2016 at 08:42:27:
I have painted my big barn twice with red paint over the past 35 years.
I think oil-based is still the best. Unfortunately, oil-based paints seem to be getting hard to get, because the "greenies" think it causes air pollution, and have lobbied the EPA to restrict it. Though how something that you apply maybe once every 10-15 years can be a major source of air pollution is a mystery to me.
In general--you pretty much get what you pay for. The first time I painted the barn was in 1980, with the local farm store paint. Was washing off and peeling after about 5 years.
Repainted the barn in 2003 with Sherwin-Williams oil-based barn paint. Still looking ok today. Unfortunately they don't have the oil-based barn paint in 5 gallon buckets anymore. However I was told by my local Sherwin-Williams store that they can mix five gallon buckets of oil-based and tint it with any color. Including "barn red".
For old weathered wood, I have found a preliminary coat of 25%-50% linseed oil mixed with the oil based paint you are using, followed by a topcoat of straight paint, really works good.
For my 2 cents: 1) oil-based is better 2) prime with a linseed/paint mix 3) a $20/gallon name-brand paint will do better than the $8.50 summer special at the local farm supply store
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
