Posted by Bill VA on July 20, 2016 at 12:28:23 from (67.130.51.170):
My newer JD5055d has remotes where one simply presses the male fitting into the coupler from the implement and to remove, pull out. My MF50 and a Ford 3000 have "rigged" remotes that have what look to me like large air hose quick disconnects. There is a hood with a series of balls that when the hood retracts, the balls loosen and the male hose come out. Aside from size/diameter, they look like something on an air compressor.
These newer remotes on my JD are a pain in the buttox to connect and disconnect. I've got the right male fitting on my haybine and last year with a seed drill that had a hydraulic lift. The male fitting is easy enough to attach, but unplugging can be very difficult.
I ain't getting any younger and between older age setting in, my hand grip not being the strength of a 30 year old (I think I've got some carpel tunnel setting in) and hydraulic fluid everywhere making for a slick everything....
I'm wondering if I can make a new to old hydraulic fitting/adapter as a go between using the older style hydraulic with hood and balls type fitting. Something where it's easy enough to push the hood back and release the fittings.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
