Posted by Jim Naden on July 20, 2016 at 17:23:47 from (70.198.76.221):
In Reply to: IH 966 posted by jaym1229 on July 20, 2016 at 06:15:54:
Quoting Removed, click Modern View to see
You'll need items 9,14,17, 26, 27 and 28 minimum. Select 26, 27 and 28 for use with valves 529910R93 and 529911R93.
Installing 26, 27 and 28 in the actuator can be a little difficult the first time.
I use a small screw to run down into the old cup, o-ring and backup ring to remove them. Install the new backup, then the o-ring. Carefully press the cup into the actuator then finish setting it with a pin punch that just fits in the cup, I have one with the corners rounded off just for this purpose. When done there should be a substantial drag on the actuator piston, (item 8).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
