This is what I was thinking,,, he did a great job,, but this is actually my cousin who I help out all year long, I rake his hay, I have worked his hay ground, loaned him a tractor for 10 years to pull his baler,,He also use my tractor and swather to cut 50 acres at least three times with never a offer to pay a dime (oh did I say I supplied the fuel and twine all those years and never asked a dime) loaned him my loader tractor for sweeping in his small squares,,,(when I went to bring it back home I had to put gas in it as it was bone dry, I waited two weeks for him to bring drive it across the road to me) and more that I have never asked a dime for,,, also supplied the fuel,,, I always have helped my neighbors/family ect as I have a lot of equipment and do not mind lending a hand at all,,, when I asked him if I should start charging for what I do for him he said we sure you have been screwing yourself all these years,,, well it did not sit well,, as for time,, he worked at it when he had time but it did take I would say 10 hrs total so maybe the 325 bales x 2,50 = 1062.50 is not out of line,,, I just feel for all I do for him I felt its a tad high,,, but I will pay it today in full his price,,, I will NEVER ask him to help again nor will I be running over to his place when it -20 below and the snow is 5 feet deep on his road to clean it out for free either,,, its more a matter of principle to me I guess,,, Thank You all for your input,,, I was always going to pay what he asked for but wanted a few thoughts on it thanks again cnt
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.