Posted by arko1112 on July 25, 2016 at 10:50:08 from (64.184.125.5):
Gentlemen, I'm new to this old tractor scene, but am having trouble with my Farmall C, serial # FC 29031, not Super C. I was having trouble with the hydraulics operations on my C. I have a belly mower deck on it and could not get the hydraulics to operate. Then began to hear a loud squealing from the pump housing next to the distributor, and low fluid. Long story short, I ordered a new pump, new gaskets and O rings and installed it and new hydraulic fluid and an oil change w/ filter, 5 qts. Everything worked. A short test mow of the yard, half hour or so, no hydraulics. Check of the hydro fluid all gone. I drained the engine oil 7 qts of fluid comes out. I have seen talk about an oil seal at the pump, but shouldn't that have been in the new pump I installed? Is there another route for the hydro fluid into the engine pan? Help needed...........
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
