Having owned a plow and truck (F250) I have to agree with the others.
And you really don't want to try commercial plowing with a 1/2 ton truck. Pickups are made to carry or pull a load, not to have extra weight suspended on the front nor the strain of pushing snow. It's very hard on a 3/4 and 1 ton too. But the 1/2 ton pickups really are not up to the task of commercial plowing. Wet heavy snow is brutal on them!
I now move snow with a 3 point 8' blower. I haven't had anything more than one chain and 2 bearings to repair in the last 5 years and the bearings were going, not shot when replaced, in warm weather I might add.
When I worked as a mechanic almost every pickup we worked on other than oil changes in the winter were tranny and cracked frame issues on plow trucks. That was regardless of brand!
Lot of guys here thought they were going to get rich plowing snow back in the mid 90's and bought plows for their trucks. Very few still have them except for keeping their own drives clean.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
