Posted by notjustair on July 29, 2016 at 12:06:31 from (70.195.4.22):
In Reply to: Wells and cisterns posted by Mark Robke on July 29, 2016 at 10:26:45:
The biggest cistern was dug here in '36. Since this was a dairy, the cistern for the milkhouse and barns is huge. It is 26 feet deep and 20 feet across laid up with brick. It is truly a beautiful piece of work. I can't imagine the labor it took to get it done. I still use it everyday to water the animals and garden (I just have a submersible sump pump with a garden hose attached). I was able to get it pumped almost dry many years ago in a drought and pulled out a few pipes that had fallen in it. Within a few months it had started filling back up. Last I lifted the lid it was about three feet from the top. Half of it is under the milkhouse so I have to make sure it isn't too full or the floor gets wet in the milkhouse. I use that as a chicken house now.
The cistern for the house was right next to it but was filled with sand and capped many years ago. It wasn't done right and has caused that basement wall to start caving in.
I'd be lost without the cistern here. The hydrants all run rural water so I would pay for all livestock water. All of the farms here had a cistern for the barn and one for the house. I know of one crazy old coot that still refuses to pay for water so she still uses her cistern. Must not be a good plan - she goes down the road with the water tank to fill her cistern several times a month. I wonder who she steals that water from?? Folks don't have their own wells here. The well water is too salty for use.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
