too many times ive helped people ut just to get it broke off in me. anymore I say sorry my left ankle is acting up and ant stand much.i broke it feb 1 this year and it didn't mend right so I use a cane. worse than your problem I had a guy that lived up the road that needed anything he just came in and helped himself. 1 day I was changing oil in my big tractor .parts man gave me wrong filters so had the oil out.i decided to disarm it while I was gone.i unhooked the battery and took the key.i came home and there my tractor set in my drive engine locked up.his beat up pickup was there too. only way out is the drive. he was a loud mouth guy .he said why the $%^&*() did you take the oil out n not tell me?i asked why he put the cables back on and jump start it? no reply. I said your paying for this engine. he got mad I suggested he walk home which he did.anyhow it went to cort.judge awarded me full repair bill plus a rental tractor. I let the dealer do all work cause they warrentied their work. that was 22 years ago.to this day he hasn't spoke and that's ok with me.id say hi when I seen him because I'm not stooping to his level.and no I wont work on your stuff
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
