Posted by BobReeves on August 06, 2016 at 14:01:21 from (70.184.16.104):
In Reply to: V lbelts posted by 37chief on August 06, 2016 at 13:37:59:
I have two flail mowers, Ford and JD, both only have one belt and all I know is not all belts are made the same. I was buying belts from R&R mowers and they barely lasted a full mowing season. When I got the JD mower I wanted to start with a new belt so I ordered one from a JD dealer to make sure I got the correct one. Discovered the belts between the two mowers were the same so threw the old belt off the JD on the Ford, two years later both belts look just like they did when I put them on.
The idler pulley on both flail mowers forces the belt to bend inwards, the R&R belts would start cracking and loosing rubber in chunks only leaving the outer part of the belt. Was getting ready to try a notched belt thinking the reverse bend at the idler pulley was the issue but the JD belts seemed to have solved the problem.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.