Posted by Ultradog MN on August 09, 2016 at 19:12:23 from (172.56.12.112):
In Reply to: Re: O/T ceramic tile posted by MarkB_MI on August 09, 2016 at 17:12:49:
Mark, A couple of thoughts here. You make a good point about the type of adhesive. In my post below I assumed he was applying the tile to a floor. But we don't know that for sure. He might be applying it to plywood on a wall too in which case bonding it to plywood would be fine. I would not use mastic on floor tile. It is not nearly as strong as thinset and takes longer (sometimes a couple of days) to dry/bond. Thinset will set up in just a few hours. Mastic is quite stiff and is usually used on smaller wall tiles that you can press into the adhesive. Thinset can be mixed real loose and is much better for setting larger tile - floor or wall. Anything over about 6"X6" tile is very hard to press into mastic. On large tiles it is nearly impossible to press them into mastic for an adequate bond. I rarely use mastic for anything, even small decorative tiles. With thinset you can use a wet brush to clean the excess mortar out of your joints as you go. Whatever residue remains in the joints or face of the tile can easily be cleaned the next day with water and a brush. Do that with mastic and you get a gummy mess on your hands.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
