Posted by blue water massey on August 12, 2016 at 08:31:59 from (198.254.227.107):
In Reply to: Lawn Tractor posted by Texasmark1 on August 12, 2016 at 06:50:14:
I have an MTD 46" stamped deck from 1982 gets run 6 hrs a week here only replaced the mandrels once and the bar at the out put hole due to a rock I didn't see my MF 12 from 1971 with 42" stamped deck is still going but does have a rust hole in it last yr we picked up a Cub Cadet with the 52" stamped deck and It's got thicker steel than either of the other two has already put 80+ hrs on it still looks good no cracks buddy of mine has a ransom with a welded deck have replaced mandrels twice now and I reweld seamsor brackets on it at least once a yr and he has less than 1/2 the grass to cut I've had good luck with stamped decks and don't see the cost difference in them over the welded decks as its still te same machine over them and it's not going to last as long as the deck if you don't look after them any how or hit everything but grass with them
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
