All the cast frame could have been either 4 or 6 speeds depending on if sold on steel or rubber but I was talking about the 1st to 4th speeds as compaired to the Farmall first to 4th, The Deere if 6 speed tranny have a 5th speed that the Farmalls have nothing to compair in speed unless the Farmall has the rare optional 9 speed tranny. The high speed tranny of the 2 stick models 6th in the Deere will compair to 5th in the farmall, the single stick Deere 6th will be slower than the 5th in the Farmall. Better load pulling in high but not as fast empty for road use as the 2 stick model. I do not know if the pressed frame 2 stick models were avaible on steel with 4 speeds or not. And the 6 speed was first avaible on 1941 models A & B. if sold on rubber, could have been sold as a 4 speed tractor for steel with a rubber option. All A,s 40 and down only had 4 speed with a 2 stick transmission. I do not know if late 47 to 1949 AR were 6 volt or 12 volt systems as they were still a unstyled tractor. Or if they were avaible in the gas version or not. And for brush hoging you might need the slower low gear of the single stick models or the 60. With the pressed steel frame the A was switched to 12 volt because the 6 volt did not have the power to crank a gas compression engine. The B was still kept at 6 volt as they did not need the extra power to crank of the A. If the lower compression all fuel tractors were converted to gas with parts from later gas tractors then you needed to convert to 12 volt for them to crank. And all the cast frame tractors could have been bought as hand start only with no battery or generator.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
