Posted by 01gentdc on August 20, 2016 at 17:39:28 from (184.16.195.162):
In Reply to: Corn crazy! posted by Eldon (WA) on August 20, 2016 at 17:08:10:
just laugh off the pain all the way to the bank ,./// how much were you getting for a dozen ,./ when I was barely 10yrs old we were piking a 4 acre field of golden bantam and silver queen,.that was in 1965 ,dad would pull his new ford pikup out into the field .. and all of us kids would ferry the corn to the truck where my mother would stack it in , ,most times we only got the bed level full ,but as it matured we loaded the stock raks and loaded the F 100 over the height of the cab ,,. dad sold the whole load on the Louisville hay market,.he would drop his truck loaded with a childhood friend named FRENCHY ,. around 6 am , hitch a ride to work to Lexington rd distillery,. then later afternoon have a pal drop him by the hay market ,,.. frenchy would have a wad of cash for him ,,and very little corn left in the truck,.. frenchy would holler "hurry up johnie and get us some more for tomorrow ",.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
