Posted by NCWayne on August 22, 2016 at 23:02:56 from (173.188.169.54):
Just a warning to everyone out there. If your working on a ladder with tools, either take the tools down with you when yougo, or use the holes designed to hold them.
Sunday afternoon I was working off an 8 foot step ladder and putting few nails in my shed roof. I climbed down to check on another project I had going on, and when I came back decided to move the ladder a few feet. I forgot I had left the hammer lying on the top, instead of sticking it in the hole designed for it.
The end result was about a 1" long gash on the top of my head. Thankfully it only hurt when the hammer hit it. I didn't even know I was cu for several minutes, until I took off my hat and the blood began flowing across my face.
Got the blood stopped, and got my wife to look at it. I was happy to wipe it with antibiotic and go on, but my wife said I needed to have it looked at. I figured it would take less time to hit the Fast Med, than to listen to her fuss at me, so off we went.
I came home with 3 staples in my head.......Still never really hurt, even without any deadening, beyond a slight pinching pain when the doctor stapled it. I get to wear them for 2 weeks, and then go back so they can take them out.
Like I said, always being tools down, or put them in the holes designed to keep them in place when your working......Your noggin will thank you......
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
