Posted by Billy NY on August 28, 2016 at 09:29:25 from (104.228.35.235):
In Reply to: Am I hard hearted???? posted by JD Seller on August 28, 2016 at 08:43:12:
Part of it is building to deal with it, if possible, but no it makes no sense, however many populated areas have been built in less than ideal places, that flood. Its easy to form that opinion, using the cut and dry facts that low lying areas flood, and that structures have been built in those areas that will not tolerate flooding. It's hard to figure why in the first place, but its been done since way back when. Mother nature will always win. The Jersey shore is one place that comes to mind, having lived there in a house on blocks, across the street is the Atlantic Ocean, which at times can be very destructive if you are in its path. I've been evacuated several times in the winter when I was there. My solution was to move. Downed power lines, horizontal falling snow, flooding, finding a place until its over, no fun at all.
To build or rebuild on the Jersey shore requires a lot more than typical construction per the present codes. The money people invest in these nice homes, just to have a view of the beach and ocean is staggering. I lived in a 4 room shack, that would have floated away in a flood. It's still there today though. Amazing. I'll take the eastern woodland environment, on a well drained hill over a low land area. We also seem to have abundant water supplies in our aquifer. Water be it flooding or otherwise will always be a source of problems for any society.
We saw that its not only low lying areas, dump 10" of rain on us here and you'll get incredible damage, like we saw in '11 with Irene, that was no joke, and likely more than a 100 year event. Lots of structures considered to be built in safe places were destroyed, bridges, culverts too. Our town rebuilt some of them, if this repeats, what they built will not hold up, for whatever reason the cycle continues. They did not build anything more substantial from what I saw, so maybe its based on 100 year events.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.