Posted by JerryS on September 02, 2016 at 13:33:32 from (98.80.106.16):
I have never owned or operated a tractor with a front-end loader, nor have I been around one being operated. Until now I have never felt enough of a need to justify getting one. I would consider getting one, but I think the odds of finding one in my area that would fit my '69 Ford 4000, that would be sold separately from a tractor, and for a price that I could afford, would be kinda slim. I have no hay to move around, I have no manure to shovel, and I have no dirt to relocate. My only need would be for something to bunch up brush and move it to a burn pile. I'm getting too old to do much of this by hand any more, so if I expect to keep up my 15 wooded acres I'm going to need help from my equipment.
I'm now thinking that for the occasional brush pushing and bunching that I would need to do, I could do it just as well using the three-point on the rear of the tractor. Have any of you bought or engineered/fabricated something along these lines? I'm thinking that some kind of a fork, with tines that would ride the ground and push up under logs and brush, maybe even grasp it with a thumb of some sort on the top, would work. It might be slow and awkward, but that's OK for no more than I would have to do.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.