Posted by Leroy on September 04, 2016 at 19:04:46 from (69.88.202.2):
In Reply to: Fertilizer posted by Mark Poss on September 04, 2016 at 17:49:38:
Actually I think you are going after things wrong. First you say checkrow. Those planters are not good for fertilizer in checking corn, only in drilling the corn where the seed is every 6-7" apart, not 36-42" as the check wire will put the seed in a clump. Checking would also put the fertilizer way to far away from the plant to do any good or else it would dump way to much right on top of the seed and burn and kill your plant. Either drill the corn instead of checking it or forget about the fertilizer. It will never be a satifactory job in any way you are going to try to do it. The other posters either missed or did not understand check row planting. So the only good advice was get a soil test. The fertilizer is supposed to be put 2" to side and 2" below the seed and unless you have the very rare disk fertilizer opener then that planter will not put the fertilizer where it is needed even if you do try to drill the corn instead of checking it. The common fertilizer placement for that planter was designed for a rate of no more than 200# per acre of 3-12-12 fertilizer, that would be only 50# per acre of a 12-12-12 fertilizer and you could not calibrate the planter for that small amount And todays fertilizer flows way faster than when that planter was designed so with any number of fertilizer you would get a burn and kill the crop amount on if you tried to put any on. I have 4 of those planters setting here in my parts row. That planter was designed back in the 30's and all fertilizer at that time was powered and not granulated like todays fertilizer. If checking you would be better off to when you know where the hills are go out with a bucket and a cup and spread that cup of fertilizer around the hill on top of the ground 8" away from any seedlings that are comming up.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
