Posted by JimS on September 05, 2016 at 18:28:29 from (50.247.112.17):
In Reply to: donkey hay posted by rkc9700 on September 05, 2016 at 18:00:02:
We got a load of hay that was foxtail infested. It was amazing how all the animals were able to eat around it. When done feeding there was a pile of foxtail and everything else eaten out. We graze in pasture with foxtail and all the animals avoid it. If a pasture is grazed hard on initial growth, the foxtail doesn't seem to get established. I am certain the animals eat it when it is young but won't touch it old. If I mow just before the foxtail tops, it stinks and the animals won't eat anything in that field.
I would caution about over feeding donkeys. One of the reasons for their popularity in third world countries is they can exist on next to nothing. Where I care take, they have three donkeys. The previous help was feeding a flake of alfalfa a day for three and the donkeys were all morbidly obese. Once over weight, it is amazingly difficult to get the weight off of them. They will put weight on their crest and even if you do get weight off, the crest will simply fall over. In other words, get them fat and they are essentially ruined. Even if seemingly ok, as they age, all sorts of problems will arise that donkeys don't normally experience. We now feed one flake of orchard grass per two head (one has since died) and they are grazing muzzled when out for the day.
I don't know if any of this helps, but this is my experience with it.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
