I had an ash firewood tree that wanted "revenge" this season. It was about 20" on a straight stump. It grew in an arch, almost horizontal about 20' up into canopy, and then had a spike about 6" diamiter that grew another 20' vertically, up into the canopy of the woods. The saw pinched imediatly as I tried a fore cut. Releived it a bit with the tip of the bar, and then cut in the sides a bit with the tip of bar. I knew it would "Barber Chair" which it did up to about 15' off the stump. It split twice and pinched my saw on the second split and pinched my saw a bit, delaying my retreat. It took some strange twists and ended up with the butt resting on my leg, just above the knee. I was able to pull my leg out from under it, but it further agrivated a previous leg injury from my school days. Pretty well back to normal weather related aches and pains in the leg now.
Just one of the hazzards of working in the woods alone, but both my dad who died from other causes, and I have done it for years and haven't either of us been killed by a tree. You need to be smarter than a tree!! Loren
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
