Posted by JD Seller on September 30, 2016 at 20:59:44 from (208.126.198.123):
In Reply to: Re: Odd top-link pin posted by vezult on September 30, 2016 at 20:18:52:
vezult: The pin in my pictures is not the exact one you should have. The correct one has a longer 3/4 diameter. Like I posted earlier the reason they designed the pin and top link like they did is you can end for end the top link an have cat I or II on the implement end. You have to have the original top link and the correct pin for this to work.
The original pins where heat treated and very tough. The tractor's lift would stall before breaking the pin.
If you needed Cat I on the implement end you would put the Cat II end of the top link against the tractor. You would slide the pin through as far as it would go and then latch/clip it in the hole closest to the stepped up shoulder. IF you needed Cat II on the implement end you put the Cat I end towards the tractor and slide the pin about a 1/3 of the way you would in the other position. Then you would have to use the other clip/pin hole to hold the pin.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
