Posted by Leroy on October 01, 2016 at 06:16:01 from (69.88.202.2):
In Reply to: Tractor for my wife posted by bja105 on October 01, 2016 at 05:41:36:
Stick with a earlier Ford like a 860; 861 or 4000 in same style as previous mentioned but make sure it has 5 speed and 2 stage clutch for live PTO. That style of live PTO thet only have to think of one thing to stop tractor and PTO, not 2 things as with your present tractor. Those are as simple and easy to operate as any tractor ever made. And good parts avaiblity and easy to work on. Low to ground and physically smaller than your present tractor and less imitading and ride would be setting in same position as present. I think you have at present 52 PTO HP and the 861 or 4000 is 48HP while the bit older 860 is 44HP. But go only with a 5 speed with 2 stage clutch. Your 4610 is just a newer version of the 4000-4100 that I had 2 of. and yes they are hard to get on, we made extra steps to do that. And I have ran non live pto tractors for years and that style of PTO on your 4610 I did not like, too complicated when you have to stop.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor: Part 2 - by Anthony West. In February 1953 production of the ETC T.V.O engine started, ready for the March 1953 press announcements. The new TVO engine had a number of improvements which resulted in a 10 per cent more power (43bhp as against 38 bhp on the earlier engine) and 10 per cent more fuel economy. Some of the improvements are listed below: Redesigned combustion chamber, improved spark plugs and positioning, plug size 14mm(earlier size 18mm).
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
