Posted by Bob in SD on October 06, 2016 at 07:52:54 from (137.216.208.116):
Thanks for all of the feedback earlier. I still have a couple of questions.
1) Would it be a bad idea to have a 6 foot box scraper behind a tractor with the rear wheels 7 feet apart? Seems like it wouldn't work right, but...
2) My driveway is about 12 feet wide, so if I maintain it at 12 feet (that is, just make it 12 feet wide) would that be easier with a 6 foot box blade? Seems like it would be hard to keep a crown it if the blade when past the middle and spilled product on the other side? Or do I want some overlap (blade wider than half the drive).
3) Is 6 foot too small to do the barnyard? I guess bigger is better out there, but I'd rather not spend more than I need to for the driveway, which is the priority or have to store a bigger blade than I need.
4) If I can't find anything used, the one I linked before a reasonable price for new? They don't seem to make them any wider than 6 feet, so that depends on your answers above.
2 1/2) Regarding the crown mentioned in #2, somebody on the another thread stated they'd rather have a plain rear blade so that they could do a crown. Can I not do a mild crown with the box blade? I guess the material ends up on the low side? Once I dig out the potholes I could put the regular blade on and re-crown? I guess I can google and find a youtube of the process.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.