Posted by t in ne on October 11, 2016 at 06:05:36 from (97.32.74.198):
In Reply to: fence recommendations posted by Bkpigs on October 10, 2016 at 19:47:56:
The ease of working with tensile vs barbed, and the time saved, you won't go back to barbed.
You have to put H braces on your ends like barbed, or it will pull them out, like barbed. You can go around a 90 degree bend, or a few 45s, and still tighten it with a spring and ratchet tensioner. Just set a larger post as deep as you can for the corner.
You can vary the post spacing to properly follow the terrain. Tamp the posts in well. At the bottom of a canyon where the post is holding it down, you may want to nail a board or something to the post to help keep it in the ground. Or if you can bulldoze a ramp, even better, whether barbed or tensile, being able to drive along it makes building, checking, and repair a lot easier.
Use a cordless impact driver and screws to put up plastic pin-lock insulators. Use a color that stands out against the post, it will save you time checking fence later, I prefer white insulators.
Get the hottest fence charger you can find. Parmak solar chargers are real good, if you don't have 110 available.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
