Posted by coonie minnie on October 14, 2016 at 06:08:59 from (50.105.201.126):
In Reply to: OT - Harvestore Silos posted by Bill VA on October 14, 2016 at 05:10:30:
There were advantages and disadvantages of each kind.
First, yes, there were wooden stave silos, as well as stone silos. Back in the day, those were quite common. In my neighborhood, there were quite a few stone, square silos- these were some of the earliest in WI> Poured concrete and concrete stave came next. Harvestore came on the scene after WWII, and offered the sealed approach- which worked, provided nothing got a leak. Leaky harvestores are common though, usually resulting in a lot of spoiled feed.
Concrete silos were never really replaced by harvestores- in fact there are still a few built today. Unloaders for concrete silos came on the scene in the 1950s- and while they unloaded from the top, which required climbing, you could fix the unloader a lot easier. Concrete silos also allowed farmers to put feed in wetter than a Harvestore, which can mean better quality especially if it means beating a rainstorm on some hay. Wetter corn silage is also more digestible. If feed was put in a Harvestore too wet, it could freeze to the sides, and with a harvestore the feed has to keep sliding down to the unloader. If the feed froze on one side, it usually meant the silo got lopsided, and often collapsed.
Today more feed is put in bags or bunker silos. The main driving force behind that is faster filling, and less capital cost. Often times though, feed quality is less than with upright silos.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.