sitting this one out . gonna get healthy and run for commissioner again in 2018..I was 3rd district commissioner of Harrison county from 2003-07 ,Got Farmland preservation going , I feared the Council would not continue to fund my efforts , So I Ran and went to county council at large in 2008, ,coupled with the efforts of George Rogers Clark Land Trust ,we continue to preserve farmland in Harrison county and adjoining counties as well . , I will complete my 2nd term on the county council at the end of yr,,.. it was a very good privelage and honor to serve ,and I was blessed with a lot of good minds and helping hands that helped me get things done,. BUT ,i got health problems , and I Need a break ,.ie/// this past march 7th they cut me open and took a foot of my colon out that was cancerous,. I have completed 12 chemo treatments ,, I am now cancer free,,but still feeling the after affects of chemo nearly a month later .//. although beforehand I had said I would take ,another term on the council ,. as soon as I found what was dealt me I decided against pushing a hard run , although I idled back, I did not suspend my campaign ...I spent 422 bux on my campaign while the other 4 spent thousands and I lost by 100 votes,,. finishing with7500votes behind the top vote getter who had 7900,there were 4 of us within 500 votes of one another ,. the at large council selects the top 3 vote winners of each party in the primary election to run in the fall,.those top 3 winners will be the 3 new council members,,,. in 2 yrs we will elect 4 district members
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
