Posted by wilson ind on November 08, 2016 at 16:41:11 from (12.201.39.102):
Had Dr appointment in Bloomington Ind today, which is 42 miles from home. You guys that go by minutes don't know what to tell you. Today in light rain and traffic not same distance in minuets as last winter nor same as in past with appointment at 1:00 pm.I need a cold water heater to finish remodel. Priced at menards, only $3 less than local so will buy local. Asked in front where cold water heaters were as cannot walk very far. Clerk said they did not sell cold water heaters they sold hot water heaters. I said ok, then clerk asked why I wanted a cold water heater. I explained the water comes into house cold and I wanted a machine to heat the water. After the water was hot I did not want to heat it more. Fellow though a bit then said you are very right, we should be advertising cold water heater heaters but thought locals would not be smart enough to understand the difference. I did buy couple of items not offered locally. Nice fellow helped this old man load and secure items. He was a little slow and I do respect any company that hired folks not as most of us are. I even gave him a generous tip.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
