Re: How do you get the front crank pulley off a farmall super c
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk ]
Posted by George on October 05, 1998 at 18:01:02:
In Reply to: How do you get the front crank pulley off a farmall super c posted by Jim Smith on October 05, 1998 at 11:46:03:
: I'd like to put a new front crank seal on. I do not see any way to get the pulley off. I see no bolts, nuts, set screws etc. I have a good puller but I'm not sure what to do so I don't break it. You should have a bearing spitter to get around the pully as much as possible. Don't try to pull it without an even pull all the way around the pulley or it will break. There is nothing holding it on, it is a tight press fit. Be careful putting it back on also. Hammering it back on is hard on the thrust bearing.
Follow Ups:
Post a Followup
|
