I would try mid Michigan pipe 773 9890. Their address is 5139 E River Rd. in mt pleasant. If your familar at all with mp then this is east of Delfield on the corner of River and Isabella Rds. If unfamiliar, from clare go south on mission rd through rosebush then 5 miles. It will be 1/2 mile south of "THE DINER" Road only goes east. If you pass Dewitt lumber (mission lumber) you just passed the road. River Rd curves passed the race track, delfield and stops. Keep going on gravel to dead end.
Next choice would be Bills custom fab shop.772 5817. He is on Grover Dr. It is a dead end road that paralells the west side of the expressway north off broomfield rd. just east of Isabella rd.
3d choice to try is unknown name pipe/metal yard 1/4 mile north of M20 east and Coleman Rd. OIL CITY STOP LIGHT. Place has lots of pipe of bigger sizes laying round there. Don't know owner, hours or anything but do see movement often.
You may try Fairs Salvage just south of clare, 386 7552 as they are scrap buyers and their intentory is always changing. If they don't have it they may be able to point you in another direction. Very honest and nice folks there.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
