Posted by pete 23 on November 18, 2016 at 11:05:51 from (74.33.107.97):
In Reply to: Interesting posted by notjustair on November 17, 2016 at 19:56:44:
The old 216 & 235 chev dipper engines ran at 14 psi oil pressure. There was a nozzle in the pan that sprayed into the dipper & GM had a tool for aligning those nozzles so the oil actually sprayed in the right direction. Imagine the actual oil pressure into the rod when that engine is wound up with the dipper catching that spray of oil. I laid under more than a few. It was a doggone old 41 chev that got me into the wrenching business. I bought it and six days later it broke the crankshaft and block. When I looked it over , before buying, the rear main was leaking pretty bad. The dealer pulled pan and replaced seal, or part of it at least. He must have tightened that rear main putting a strain on crank to cause it to break shortly. Never know. But, anyway, I put a 48' 235 engine in it. Next year, drove it 1300 miles to Atlanta while in Army to attend engine rebuild school, sold it for 40 bucks, end of story.
Chev used babbited rods until going to replaceable inserts in the 53 power glide and all engines next year.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
