We have one tractor that tends to make the most trips to our local grain elevators in the fall, pulling 700 to 900 bushels of grain with each trip. This tractor also is hooked up to the planter in the spring and on the stalk chopper in the fall. I have seen Good Year Dyna Torq II radials on a tractor of ours and they lasted a long time. I have seen the Firestone 23 degree radials on a similar model and size tractor and they wore rapidly on the road. I think they are a great tire in the field, but from what I have been told by independent tire dealers, the flatter the angle on the lug, the more rapidly they will wear. The Firestone tires were about 80 percent worn out in a matter of 700 hours on the tractor. I replaced those Firestone tires with the Michelin radial tires, which I believe the model tire is the AgriBib. I asked questions at farm shows about tractor tires and longevity in road use. This was the tire consistently recommended to me by every independent tire dealer I talked with. I currently believe we have a little over 200 hours on the tractor since the tires were installed and they look good so far, as compared to the Firestone tires showing wear the very first year when hauling grain. You can ask me what I think of these Michelin tires in a couple more years when we get some more road time on the tread. I will add the comment made to me by one of the tire dealers I talked with. He had indicated the Michelin tires are a common brand in Europe, where tractors spend more time on the road, as compared to here in the United States.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
