Posted by paul on November 21, 2016 at 12:43:51 from (76.77.197.114):
In Reply to: Concrete Question posted by pburchett on November 21, 2016 at 11:08:15:
A whole lot of concrete trucks running here now, last minute jobs. The high is in the mid 30s for the past week now, low is touching the teens.
Here is my understanding:
Concrete when it cures is a chemical process, the water doesn't just dry out of it but it is like a fire, some chemical reactions are going on slowly.
This chemical reaction creates some heat, so concrete pour at 25 degrees or so isn't such a bad thing. It will warm itself above freezing. As long as you have something, a frame or a concrete blanket over it to keep the heat from wicking away fast over night. The surface could freeze up if totally exposed and chip up.
However, after a week or so, the chemical process slows down and less heat is generated, but there may still be a fair amount of unconverted water left in your concrete. -That- is when it can freeze and hurt your concrete? This is when you really need to protect it from bitter cold for a few weeks.
At the temperatures you mention, there is no worry about any issues.
But what wil you have in a week, or three weeks from now? Same temps and you should be fine, but if the temp dips down to 10 degrees or so, you could have issues?
The antifreeze in the water in the concrete is a miserable deal, I would avoid that if I could.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
