Posted by Case Nutty 1660 on November 23, 2016 at 08:08:39 from (75.127.24.87):
In Reply to: case 580ck advise posted by randy1 on November 23, 2016 at 02:43:25:
You will wonder what you have done without it all these years I use my 580CK almost every day for something great power all around very strong and fast hydraulics and easy to work on,, I use mine for loading bales all kinds of dirt lobs and also in snow removal,, we sold hundreds of these machines from 1966 through 1971 when the "B" series came to be, if that one is equipped with a power shuttle always let it run a few min to get the shuttle warmed up before running it the first time each day,, I start mine and put the shuttle in fwd or rev with trans in "N" this will make the clutch packs last many thousands of hours, couple pics of mine at work in the past weeks,, the cab on mine is for a "B" series as the CK never had a factory cab option, I also have a MOD hitch for mine as well as a backhoe, mine was ordered in as a skip loader with 3pth pto and remote hyd and drawbar cnt
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
