Posted by MarkB_MI on November 26, 2016 at 05:39:15 from (70.194.7.218):
I had to remove the handle from a shower valve yesterday. Although I was able to get the set screw backed out enough to pull the handle, the screw became stuck and wouldn't move in either direction. A replacement handle is 25 bucks, so I decided to see if I could salvage the old handle.
First off I filled the handle with Kroil and let it sit for an hour. No difference.
I'd never tried applying heat to pot metal before, but I figured worst case I'd have a pool of molten zinc on my workbench. I put my smallest brazing tip on my oxyacetylene torch, placed the lever in the vise using padded jaws, and started heating the lever hub. After a couple of minutes of carefully heating the hub and trying to turn the screw it came free. The stainless screw was still in good shape so I just dipped it in grease and put it back in. The lever looks good as new and the chrome plating doesn't appear to be damaged at all. I'm sure I'll use this technique again in the future.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.