Posted by flying h on November 27, 2016 at 14:24:14 from (184.53.32.223):
In Reply to: Round bale feeders posted by rrlund on November 27, 2016 at 12:17:37:
I started a cow calf operation with my brother about 22 years ago. He had about 50 head of cows at the time and I'd just bought a place and 50 of my own. The man I got the cows from sold us his used round feeders and we still are using them. Guy here makes them still. 1 inch square tube 11 gauge in an 8 foot circle. Three bands on the bottom half and one on top. The bars are angled and welded all 4 places. Only trouble I've had is they will rust out on the bottom ring if you don't get them up out of the muck to dry out for the summer. Cows push them around on frozen or dry ground but only ones that have any damage is where I got lazy and poked em with the loader. they are not hay-savers but they don't waste a lot. I made a couple of them myself out of 3/4 inch schedule 40 pipe that are 10 feet across and they waste almost nothing. I guess they have to reach for the hay so they don't back out so much. I don't try to stack the bales in them. One to a feeder so they clean it up each time works best. I've gotten 20+ years out of these and paid 75 bucks for them used. Not complaining!!! Local CO-OP sells the original ones for around 300
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
