Could you replace the "piece of tin" with a finish looking refrigerator door? They are painted up to look nice and if you can get one with fiberglass insulation it is easy to remove the insulation and you have a nice heat shield. Cut a few good sized vent holes in the top and bottom edge for air circulation and hang the panel by two screws you put in the brick. Just let them stick out a half inch or so and hang the door panel from them. You can take the panel down in the off season, and the white? color will not look to bad, (better than a piece of tin) for heating season. Doors come in many sizes and colors for that matter, but a light color would reflect heat back to the room. The ones with foam insulation are tough to get the foam out of usually and you don't want or need the insulation. Possibly you could chemically remove it, gas? acetone? might melt it. I have a couple of such heat sheilds, but mostly I collected refrigerator doors to use to cover my firewood stacks. Around here though you don't see them too much anymore as the electric company will give you $50 or a refrigerator when you buy a new energy efficient one, they come and pikc up the old one and you get a check in the mail.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
