Posted by coonie minnie on December 04, 2016 at 10:21:58 from (50.123.237.153):
In Reply to: Another bin question... posted by Dave H (MI) on December 04, 2016 at 09:06:24:
It will vary depending upon the size of bin- not just bushels, but height of grain- and you might find multiple combinations of height and diameter to meet your bushel requirements. Tall and narrow might mean less total concrete, but short and wide is generally easier to move air through and dry stuff with.
The last bin we built was relatively small (30' x 9 rings, not quite 15,000 bu) to use for cooling out of the dryer. The pad was 2 foot thick around the outside, and I think 6" or 8" in the center. You can set them lower to the ground, without the wall, but there can be drainage issues in locations with those (you don't want a flood to enter the bin!) and it limits the options for unloading augers.
I'd talk to a dealer. It won't cost you anything to dream big. And before I bought a used bin, I'd want to know what a new one cost. The dealer can give you specs for the floor, and will have a good idea how much re-bar you need.
As far as cost benefit goes, I think you will find it won't be free, but has a much greater return than anything with rubber tires.
A wise grain market one said, "You are either going to pay for your bin, or someone else's." It might as well be yours, and not the elevator's.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
