Posted by hd6gtom on December 08, 2016 at 12:38:28 from (173.29.173.135):
In Reply to: NEW REAR TIRES posted by JDBRIDER on December 08, 2016 at 10:50:17:
JD do NOT use grease. It will eventually destroy the rubber around the bead. seen it too many times. Get some tire mounting liquid from NaPA. It has an anti rust built into it. Not as slick as some but for the size tires you are mounting it will be fine. It is far slicker than any dish soap. You have picked a good brand of tire to put on. I sold and mounted many semi loads of them. Please tell us you are putting new tubes in too. A duck billed tire hammer to break down the outside bead, take your bars and pull the outside bead off. that will allow you a little more room on the tractor to work the inside bead. Once the inside bead is broken down, pull the old tube, pop off the tire and you are ready to wire brush the rim. If I were you, I would have it close to electricity and use a drill or 4" grinder to remove any rust, far easier than a scraper and hand held wire brush. Simply lube up the new tire, make sure the tread is the right way, make sure the valve stem hole is the right way and mount her up. Put lots of lube on the rim before you start to air it up.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.