Posted by big tee on December 11, 2016 at 14:41:07 from (199.120.66.137):
It has been talked about on this site and others so I thought I would try it. That is putting a pipe over the cutting edge of your snow pusher. I bought a bigger bucket for my loader last year with a very sharp cutting edge and there was no frost in the ground and I had rerocked my yard with bigger crushed lime stone so I sometimes got more rock than snow. I had 1.25 and 2 in. ID pipe so I was not sure which one to use so I cut a short chunk of the 2 in. and split it with the chopsaw and slid it over the cutting edge to see how it looked. Looked good so never even tried the smaller pipe. Used my plasma cutter and a piece of angle iron for a straight edge and took about 3/4 of an in. out of the pipe. Had the bucket standing on edge but couldn't keep the clamps from slipping off until I put the forklift on it for weight. Used tabs on both sides with 3/8's bolts with 3/4 in. nuts for spacers. Had to use what I call "my Polish drill press" to drill the holes to hold it on. Used it today and it works 10 times better than I thought it would---level the bucket and put the loader in float. So thanks to you GOOd people that showed me the way.---Tee
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
