Posted by JD Seller on December 11, 2016 at 17:49:17 from (208.126.196.24):
In Reply to: So what happens now? posted by Dave H (MI) on December 11, 2016 at 08:09:40:
Dave if you only have a few inches of snow then you can run the soybeans in the snow. Any more than that and you done until the snow melts. I have ran soybeans with snow in them. I had the best luck after dark or on cloudy days. If the sun shines it will warm the machine and plants up enough that you will have trouble. This next week it is going to get very cold here. IF you only have a few inches of snow I would try to run the beans when we get these sub zero days/nights. When it is real cold and the machine is cold the snow will blow out just like dirt/dust. If the sun warms the pods at all then they will stick to the snow and you will plug the sieves.
Now as far as the snow hurting the soybeans themselves. It usually does not damage the quality of them this early. Later in the season if they have been under snow all winter they can mold. The biggest concern I would have is pod shell. When the pods goes from wet to dry or wet to frozen they will eventually split open and drop all the beans on the ground. I have never had soybeans last until spring. They usually are shelled out by late January or early February around here. So I would try them ASAP even if you have snow. If you wait too long you will get nothing. They will NOT stand until spring in snowy and freezing weather.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
