Yes, the smaller bin will cost more per bu, but not a whole lot more. The bigger ones need heavier thickness steel side sheets, stiffener bars, etc. Getting cheaper as it gets bigger makes more of a difference between 5,000 and 50000 or 500000, than it does between 5000 and 15ooo.
My point was that while you are saving a little on upfront cost, you aren't saving much... I've always found it cheapest to buy the best I could afford- there usually were a lot of hidden costs in something "cheap".
Keep in mind the $ 1.35 a bushel bought a lot of things you are not getting with these... a power sweep, not just a sweep, a big fan that will move a lot of air, a stairs, a full aeration floor. And it is new, and will probably last twice as long... so capital costs per annum can be divided by twice as many years if you choose.
Keep in mind this is an investment, not a cost. A few weeks ago JD Seller and myself pointed out several ways in which the bin can make you money. The difference in cost between used and new is only .50 a bushel. You can make that back in one year. How much was moisture dockage and shrink on your beans? If you could have harvested when you wanted to, what would it be?
Also remember you will have time in taking this thing down. And risk. You could bend something and need to replace it. You could get hurt. you will still need to buy at least some new fasteners. you will still need to pour a pad. If you got these for say, $1500, it might be worth risking some of the above. $5k however, to me is too much for what is still ahead.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
