Where I live here in central Ohio there were about 16 "Clinton formation" wells drilled with in a 2-3 mile radius of me, 2800-3200 ft deep, and 3 Rose Run formation wells at around 7,000ft,, all were Fracked..I have a very good water well drilled to 100 ft. good clear tasty water..Fracking did not effect any ones water around here..Just saying..a lot of blown out of portion news out there..Some areas will have bad water no matter what happens,,same with earth Quakes,, there is a very deep salt water disposal well,about 10,000 ft. deep south of me about 7 miles that have been taking in water for the past 35 years,,also with no affect to the area... there is also 3 "major" pipe lines west of me 2 miles that go east and west to Texas and Oklahoma, one is the Rocky express, one is 48" the other 2 are 30",,no issues from them ether..It seems that a lot of bad publicity is put out there by a few that really have no idea of what they are talking about..
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
