Posted by Turnaround on December 21, 2016 at 06:27:03 from (67.237.87.156):
In Reply to: Re: Homemade pto? posted by Turnaround on November 01, 2016 at 16:50:19:
My 28 year old friend and I (79 years old) got a 4.11 gear ratio Ford Ranger rear axle welded to an old trailer tongue, and then mounted an extra set of Ferris zero turn wheels and tires. The overall gear ratio worked pretty well as the PRO spins pretty fast at ground speed. I had not transported my Ferris yet, to the site with the Millcreek manure spreader ( and mountain of several year old manure from the farm's previous owner) so I hooked my spreader to the homemade PTO mule axle, then hooked the whole rig to my 61" Skags Turf Tiger. The Skags towed the rig wonderfully well. It flings manure like a champ, and the Ranger axle is heavy enough to gain traction with out creating tire drag marks in the samdy paddocks. My rig might not work with some of your monster manure rigs, and great loads of wet manure, but it sure lets me use a PTO driven Millcreek manure spreader on a property with no real PTO capable tractor.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
