Posted by robert major on December 21, 2016 at 23:16:27 from (216.81.4.251):
In Reply to: MF 1085 posted by CBBC on December 21, 2016 at 10:49:50:
Hi Now i know everybody's gonna jump on me and say this is the most stupid micky mouse idea and I should be shot for suggesting it. A buddy of mine over in Saskatchewan, has an 1135 did the same thing from what he said. It hadn't burned the sleeve, but had been running rough on 4 cyls for a fair while and is pretty well a worn out tractor though.
What he said he did was build up the low spot with weld grind and file it all back true and stuffed it back together with a new gasket. It is still running good, but he found another 1135 tractor. It has low hours and one owner he's going to use it when this one drops dead L.O.L . If you can't find a motor if the heads off it's half way to doing the sleeves, Might be worth a shot if chem metal held it for a good while over the years.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
