At the risk of being called a Billy Bob, shot down in flames, swore at etc I will say that the reality is that since the branch circuits in your house are wired with only two wires that it does not meet current codes no matter what you do. Thus saying that wiring the fixture one way or the other meets or doesn't meet code is bunk. Wire anyway you wish it isnt going to meet current residential codes. As for which way it is safe, meaning absolutely safe vs dangerous it makes absolutely no difference because "safe" is not a definitive term, it is relative term. That is why codes keep changing, Ohms law hasnt changed, just the public view of "safe" thus we now have 3 wire 110 4 wire 220 etc. A question for those who would argue my point is this; If a lamp requires the leg wire to the center and the neutral wire to to go to the metal threads to be safe vs dangerouse please tell me why can we go to any store, purchase a desk lamp with a two wire cord that has a nice little UL laboratories listed tag on it yet it can be plugged in either way which cases not only the lamp but the switch being reversed?? UL labs must be out to kill me?? LOL
All that being said, IF you can determine which one of those wires is indeed the one that has 110V potential above ground then by all means attach that wire to the center contact for the bulb because it is indeed the prim and proper and safest way to do it. If you cannot determine which is which then attach the wires, put the fixture back in the wall and quit worrying about it. One way being safer than the other is cutting some pretty fine hairs that I personally dont cut.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
