wfw: while you can certainly optimize ammunition for a rifle, especially if you reload, most lever-action rifles will shoot just fine with standard .357 ammunition, and many will also take .38 Special as well. The concept of common ammunition in a rifle and pistol is hardly a new one--for instance the Winchester 1873 in .44 WCF (.44-40) which was also used in the Colt Single Action Army revolver, as were other calibers of similar size and power. There are exceptions, but usually they involve pistol ammo that will not work well in rifles--typically things like wadcutter bullets that don't feed well through a lever-action's mechanism. Still, the vast majority of commonly-available pistol ammunition will work just fine in a lever-action rifle--it's just a matter of doing a bit of research and experimentation on what works well with the specific model you have. Another thought is a new-ish offering from Ruger--a model of their long-proven M77 bolt-action rifle made specifically for the .357. Video below is from Hickok45, who I consider to be one of the better Youtube shooting channels, and with over 2 million subscribers he has a considerable following. The .357 magnum makes for a very nice short-range light-recoiling cartridge that, in my opinion, would make a dandy gun for young or slender shooters while still having enough power to humanely kill deer-sized game with proper bullet placement, and several states have recently made it a legal caliber in areas that used to be shotgun-only.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.