Posted by caseman46 on December 22, 2016 at 12:23:03 from (69.171.121.11):
In Reply to: Old farm plans posted by Bkpigs on December 21, 2016 at 22:00:14:
. "Equipment for the Farm and Farmstead" is a hard back book copywrited in 1917, written by an Agriculture Engineer from Ohio State University. This book has many plans of all types of farm buildings from A-frame farrowing houses to fancy gambrel-roofed dairy barns. Included is a plan for a well equipped shop powered by a single cylinder hit-or-miss style engine with line shafts and flat belts to each tool. House plans with attention to indoor plumbing and lighting (acetylene gas, kerosene and modern electric) are included. Many of you may live on CENTURY FARMS where old buildings of these designs still stand and even used. Farm equipment shown is powered both by horse and tractor, with the book's final chapter devoted to gas engines. Scenes of farm life in the book are portrayed in museums and re-enacted at antique tractor shows. If you're interested in actual readable copies of any of the plans, contact me and I will gladly assist
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
